PowerPlasma 25i XTR
For those looking for the ultimate 120V only plasma cutter with the best cutting performance and portability in the industry, the Everlast PowerPlasma 25i XTR delivers. With a maximum of 25 Amps output, the unit will sever up to 3/8", but also will deliver beautiful cuts right up to 1/4" thick with decent cut speed and low amounts of dross. With a modern, blow-back style torch the unit avoids the pitfalls of old cheaper High Frequency designs, which include electronic interference and constant maintenance of the High Frequency points.
The unit has a simple front, single knob panel which outlines the expected output capacity on 15A, 20A, and 30A breakers. This acts as a guide to prevent accidental tripping of the breakers, if a 30A breaker isn't available. This unit is perfect for operating on 4000 Watt Clean Power (5% or less THD) rated 120V generators.
As far as compressors go, this unit will operate on almost any 20 gallon compressor with moderate cutting. For heavy cutting, consider a 30 gallon compressor.
Features & Benefits | Features & Benefits:
|
---|---|
What's Included | Standard Equipment:
|
Tech Specs | Tech Specs Type:
IGBT
Voltage/phase:
120V
Output Amp/Volt Range:
OCV:
400V Max Inrush ( I1MAX ) Amps:
Maximum Rated (I1EFF ) Input Amps:
110V: 18A Duty Cycle At Rated Amps/Volts:
120V: 35% @ 25A/90V Arc Start Type:
Blow Back (Piston type)
PilotArc:
Yes
Torch Type:
Innotec iPT 25 (S45 Consumables) CNC Interface Port:
No Adjustable Post Flow Timer:
No
Gouging:
Not Recommended
Recommended Cutting Air Pressure:
55-65 psi Recommended Compressor Capacity:
3.5 cfm with 25 gallon tank OK-to-Cut Indicator/Low Air pressure safety:
Yes
|
Minimum Maxmimum | Minimum/Maximum:
Plasma cutting quality + capacity is affected by several factors. |
Optional Equipment | Optional Equipment:
|
Notes | Product Note
|