PowerPlasma 62i with CNC Package
The PowerPlasma 62i is now available in a CNC only package. This unit comes with all the basics to get started with your Plasma table, including a CNC port, and CNC torch. It has has the convenience, portability and performance that will meet the needs of everyone from the weekend enthusiast to the welding and fabrication shop operating a small plasma table. The PowerPlasma 62i is built on an inverter platform, making use of IGBT technology to reduce weight, and improve reliability and performance. The unit has plenty of cut capacity with a recommended 3/8" regular cuts, maximum clean cut capability is up to 3/4" (at reduced speeds). Pierce up to 5/16" for production cutting. The new iPT 60i CNC torch is a part of our package and features a proven long life with blow back start, pilot arc and a variety of consumable choices. The PowerPlasma 62i features a 3 second tip saver to reduce premature consumable wear by limiting pilot arc on time, if no cutting is taking place.
|Features & Benefits||
Features & Benefits
220/240 V 1 Phase
Output Amp/Volt Range:
Max Inrush ( I1MAX ) Amps:
Maximum Rated (I1EFF ) Input Amps:
Duty Cycle At Rated Amps/Volts:
Arc Start Type:
Blow Back (Piston type)
Weight: 58 lb
Italian designed iPT 60i torch
CNC Interface Port:
Adjustable Post Flow Timer:
Light to Medium
Recommended Cutting Air Pressure:
Recommended Compressor Capacity:
6CFM @ 90 psi/ 30 gallon tank
OK-to-Cut Indicator/Low Air pressure safety:
Plasma cutting capacity is affected by several factors.
Ideal cutting conditions require dry air, new consumables, proper air pressure, etc.
Quality of cut depends upon consumable orifice size, standoff height, and travel speed.
To improve consumable life and prevent torch damage, the customer must supply and install a separate air dryer inline in addition to the regulator/water trap supplied by Everlast. The water trap Everlast supplies with the unit is not designed to remove all moisture from the air.